1 the standard weight of the panel is 32 kg/m2 and it allows manual handling without the need to use lifting equipment.

2 to assemble Minimag panels it is necessary to use:

• Only 2 contrast tie-rods for casting up to 3.0 m in height with pressures of 60 kN/m2. This allows reducing significantly reinforcement and dismantling times, it allows operating easily and safely because personnel can perform all operations on the ground without the need to “climb on the formwork” or to use ladders (the upper bar is placed at 2.10 m in height).

• 2 connection clamps are necessary to ensure the perfect alignment of the formworks and a quick assembly.

3 the panels of all sizes can be used both vertically and horizontally.

4 the adjustable clamp is suitable to connect plywood panels up to 150 mm of thickness and it allows the connection to the MAGNUMsystem panels.

5 The MINIMAG system can be combined with MAGNUM panels (large surface formworks) by using an adjustable clamp for greater flexibility and productivity. At industrial sites where large handmade products are used (suitable for use with the MAGNUM system) also when spaces or niches are present (ideal for the MINIMAG system), the ability to integrate the two lines of products allows keeping the productivity very high.

6 the MINIMAG panels can be reinforced inclined.

• foundation plinths and curbs

• pillars

• bearing walls and walls in general

• lift wells

• stairwells

• retaining walls